![]() Pumping element does not work properly 1. Clean the oil seal seat and replace oil seal Fork has not been used for some time and is locked out Oil seals and dust seals tend to stick to stanchions Raise dust seal and lubricate stanchion tube, dust seal and oil seal Excessive play of stanchions in the sliders Pilot bushings are worn Replace pilot bushings Fork rebounds too fast in any adjuster position Dirt inside fork legs Clean carefully and change oil Adjuster position does not affect fork operation 1. Replace crown/stanchions assembly, oil seals and dust seals 3. Replace oil seal Oil leaking through the bottom of slider O-ring on pumping rod nut damaged Replace the O-ring 2. Preload FAILURES CAUSES REMEDIES Oil leaking though the top of slider 1. ![]() Always refer to this table before doing any repair work. It also indicates possible causes and suggests a remedy. ![]() FAILURES, CAUSES AND REMEDIES This paragraph reports some failures that may occur when using the fork.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |